Filter
Top Products
Model H7757 3" Mini Wool Buffer-8-
2. Attach the eye shield to the bracket
with the 4mm Phillips head screws, flat
washers, lock washers and hex nuts as
shown in Figure 4. The hex nut should
be tightened to a point where the eye
shields are stiff to move.
Figure 4. Eye Shield Installation.
Screw
Hex Nut
Flat Washer
The buffer must be mounted to a benchtop
or mounting board before it can be used.
An unmounted buffer can become unbal-
anced when in use, potentially causing
serious injury.
Components/Hardware Required Qty
Hex Bolts M4-.7 (length varies) ................ 3
Hex Nuts M4-.7 ........................................ 3
Flat Washers 4mm ................................... 3
Lock Washers 4mm .................................. 3
Mounting
To secure the buffer to a benchtop or
mounting board:
1. Place the buffer on a workbench or
mounting board no smaller than 12"W
x 10"D.
2. Using the 4mm holes in the buffer base
as a template, drill holes through the
mounting board or benchtop as appro-
priate.
3. Secure the buffer to the benchtop or
mounting board with 4mm hex bolts,
washers, lock washers, and hex nuts
as shown in Figures 5 & 6.
Figure 5. Mounting the buffer (front).
Figure 6. Mounting the buffer (back).
Figure 3. Eye Shield Bracket Installation.
Screw
Hex Nut
Flat Washer
Lock Washer