Filter
Top Products
Model H7757 3" Mini Wool Buffer -7-
The tool rests attach to the inward side of
the guard and must be used to support
the workpiece during operation. Failure to
install and use the tool rests can lead to
serious personal injury!
Components/Hardware Required Qty
Tool Rests ................................................ 2
Wing Bolts M3-.5 x 10 .............................. 2
Flat Washers 4mm ................................... 2
To install the tool rests:
1. Loosely attach the tool rests perpen-
dicular to the surface of each wheel
with the wing bolts and 4mm washers.
Tool Rests
Figure 2. Tool Rest Installation.
1
⁄16" Gap
Wing Bolt
Flat Washer
Tool Rest
The eye shield must be positioned between
the grinding or buffing wheel and the
operator’s face to protect the operator from
flying debris. The eye shields are not a
replacement for safety glasses!
Components/Hardware Required Qty
Eye Shields .............................................. 2
Eye Shield Brackets ................................. 2
Phillips Head Screws M4-.7 x 40 ............. 2
Hex Nuts M4-.7 ........................................ 2
Flat Washers 4mm ................................... 2
Phillips Head Screws M5-.8 x 12 ............. 4
Flat Washers 5mm ................................... 4
Hex Nuts M5-.8 ........................................ 4
Lock Washers 5mm .................................. 4
Lock Washers 4mm .................................. 2
To install the eye shields:
1. Attach the eye shield brackets to the
buffer with the 5mm Phillips head
screws, flat washers, lock washers and
hex nuts, as shown in Figure 3.
Eye Shields
Items Needed
for Set Up
The following items are needed to com-
plete the set up process, but are not
included with your machine:
Description Qty
Safety Glasses (for each person) ............. 1
Phillips Head Screwdriver ........................ 1
Optional Items for Mounting
Drill with 4mm bit ...................................... 1
Wrench 4mm ............................................ 1
Hex Bolts M4x.7 (length varies) ............... 3
Hex Nuts M4-.7 ........................................ 3
Flat Washers 4mm ................................... 3
Lock Washers 4mm .................................. 3
2. Adjust both tool rests approximately
1
⁄8"
from the grinding and buffing wheels
and tighten the wing bolts. Figure 2
shows the correct adjustment for the
tool rest at the grinding wheel.