Filter
Top Products
-12-
Model G0477 15" Planer/Moulder
Inventory
Inventory (Figure 3) Qty
A. Long Frames .............................................. 2
B. Short Frames .............................................. 2
C. Plain Legs ................................................... 2
D. Notched Legs ............................................. 2
E. Long Braces ............................................... 2
F. Short Braces .............................................. 2
G. Planer/moulder (not shown) ........................ 1
Components and Hardware (not shown)
• Roller Adjustment Wrench .......................... 1
• Open-End Wrench 8/10mm ........................ 1
• Rubber Grip Magnets ................................. 2
• Hex Wrench 4mm ....................................... 1
• Dust Chute ................................................. 1
• Dust Chute Adapter .................................... 1
• Dust Collection Bag .................................... 1
• Bag Clamp .................................................. 1
• Cap Screw M6-1 x 25 ................................. 1
• Button Head Cap Screw M6-1 x 25 ........... 1
• Crank Handle ............................................. 1
• Handle Plug ................................................ 1
• Phillips Head Screw M6-1 x 25 .................. 1
• Cap Screws #10-32 x 2
3
⁄8" ......................... 2
• Flat Washers #10........................................ 2
• Wing Screws
1
⁄4-20 x 1
1
⁄4" ........................... 4
• Flat Washers
1
⁄4" ......................................... 4
• Threaded Guide Inserts ........................... 12
• Hex Bolts M8-1.25 x 80 (Stand) ................. 4
• Flat Washers 8mm (Stand) ........................ 8
• Hex Nuts M8-1.25 (Stand) .......................... 4
• Carriage Bolts
5
⁄16-18 x
3
⁄4" (Stand) ........... 24
• Flange Nuts
5
⁄16-18 (Stand) ....................... 24
The Model G0477 is a
very heavy machine.
Serious personal injury
may occur if safe mov-
ing methods are not fol-
lowed. To be safe, you
will need assistance
when moving the ship-
ping box and removing
the machine from the
box.
Figure 3. G0477 Inventory.
A
B
C
D
E
F
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.