Filter
Top Products
Full Load Amperage Draw
Power Supply Circuit Requirements
If you are unsure about
the wiring codes in your area or you plan to
connect your machine to a shared circuit, con-
sult a qualified electrician.
SECTION 2: CIRCUIT REQUIREMENTS
Power Connection Device
Figure 7
Serious personal injury could occur if you
connect the machine to power before com-
pleting the setup process. DO NOT connect
the machine to the power until instructed
later in this manual.
Electrocution or fire could
result if machine is not
grounded and installed in
compliance with electrical
codes. Compliance MUST
be verified by a qualified
electrician!
NOTICE
The Model G0513/G0514 is prewired for
220V. If you plan to operate the machine at
110V, the motor must be rewired (see Page
54) and a 110V plug must be installed.
Extension Cords
<gdjcY^c\Egdc\
^h=dd`ZY
=di
CZjigVa
L5-30 GROUNDED
LOCKING
RECEPTACLE
L5-30
LOCKING
PLUG
Figure 7.
<gdjcY^c\Egdc\
8jggZci8Vggn^c\Egdc\h
6-15 PLUG
GROUNDED
6-15 RECEPTACLE