Filter
Top Products
G0538 Oscillating Spindle Sander
-11-
Figure 4. Pre-Installed Components.
Figure 3. Inventory.
Inventory
After all the parts have been removed from the
box, you should have the following items:
Inventory (Figure
3) Qty
A. Sander Unit ................................................
1
B. Sander Unit Base Plate .............................. 1
C. Sanding Sleeve and Drum 3" ..................... 1
D.
Sanding Sleeve and Drum 2" ..................... 1
E.
Sanding Sleeve and Drum 1
1
⁄2" .................. 1
F.
Sanding Sleeve and Drum
3
⁄4" .................... 1
G.
Sanding Sleeve
1
⁄2" ..................................... 1
Pre-Installed Components (Figure
4)
H. Spindle Washer
7
⁄8" ..................................... 1
I. Sanding Sleeve and Drum 1" ..................... 1
J. Throat Plate 1" ........................................... 1
Hardware Bag 1
• Wrench
9
⁄16" ................................................. 2
• Spindle Washer 1
13
⁄16" ................................ 1
• Spindle Washer
5
⁄8" ..................................... 1
• Tap Screw M4-0.7 x 12 .............................. 4
Hardware Bag 2
• Throat Plate
1
⁄2" .......................................... 1
• Throat Plate
3
⁄4" .......................................... 1
• Throat Plate 1
1
⁄2" ........................................ 1
• Throat Plate 2" ........................................... 1
• Throat Plate 3" ........................................... 1
In the event that any nonproprietary parts are
missing (e.g. a nut or a washer), we would be
glad to replace them, or for the sake of expedi
-
ency, replacements can be obtained at your local
hardware store.
A
B
C
D
F
E
G
H
I
J
NOTICE
If you have never used this type of machine
or equipment before, WE STRONGLY REC
-
OMMEND that you read books, trade maga
-
zines, or get formal training before begin
-
ning any projects. Regardless of the con
-
tent in this section, Grizzly Industrial will
not be held liable for accidents caused by
lack of training.