Filter
Top Products
-12-
G0538 Oscillating Spindle Sander
Base Attachment
The metal base plate needs to be attached to the
spindle sander before use.
Components and Hardware Needed: Qty
Tap Screw M4-0.7 x 12 .....................................
4
Sander Base Plate ............................................
1
To attach the sander base plate:
1. Examine the inside of the sander body and
remove any loose packing material found.
Note: Loose packing material inside the
sander body during operation is an imminent
fire hazard.
2. Attach the base plate to the underside of the
sander with the included M4-0.7 x 12 tap
screws.
Mounting
We strongly recommend mounting the spindle
sander to a mounting board or workbench before
being used.
Components and Hardware Needed: Qty
Hex Bolts
1
⁄4"-20 (length varies) ......................... 4
Hex Nuts
1
⁄4"-20 ................................................. 4
Flat Washers
1
⁄4" ................................................ 8
Lock Washers
1
⁄4" .............................................. 4
To secure the spindle sander to a benchtop or
mounting board:
1. Place the spindle sander on a workbench
or mounting board no smaller than 24"W x
18"D.
2. Using the
1
⁄4" holes in the sander body as a
template, drill holes through the mounting
board or benchtop as appropriate.
3. Secure the spindle sander to the benchtop
or mounting board with
1
⁄4" hex bolts, wash-
ers, lock washers, and hex nuts as shown in
Figure 5.
Figure 5. Mounting the spindle sander.
DO NOT operate the Model G0538 without an
adequate dust collection system. This saw
creates substantial amounts of wood dust
while operating. Failure to use a dust collec
-
tion system can result in respiratory illness.
Dust Collection
To connect a dust collection hose:
1. Fit the 2
1
⁄2" dust hose over the dust port
shown in
Figure 6, and secure in place with
a hose clamp
.
2. Tug the hose to ensure it does not come
off.
Figure 6. Dust port.