Filter
Top Products
G0548 2 HP Dust Collector -13-
Components and Hardware Needed: Qty
Base ..................................................................1
Casters ..............................................................4
Flange Bolts
5
⁄16"-18 x
1
⁄2"..................................16
Tools Needed:
Wrench or Socket 12mm....................................1
To assemble the dust collector base:
1. Position the base upside down.
2. Secure the casters into the mounting brack-
ets under the base with the flange bolts
(Figure 7).
Components and Hardware Needed: Qty
Base ..................................................................1
Motor and Impeller ............................................1
Flange Bolts
5
⁄16"-18 x
1
⁄2"....................................4
Tools Needed:
Wrench or Socket 12mm....................................1
To assemble the motor and impeller:
1. Flip the base over on the casters and locate
the mounting holes for the motor and
impeller.
2. Position the motor and impeller on the base
and secure them with the flange bolts
(Figure 8).
Figure 7. Caster installed on the base
mounting bracket.
Figure 8. Motor and impeller attached to base.
Motor and ImpellerBase