Filter
Top Products
-14- G0548 2 HP Dust Collector
Components and Hardware Needed: Qty
Base ..................................................................1
Canister Support ................................................1
Flange Bolts
5
⁄16"-18 x
1
⁄2"....................................2
Tools Needed:
Wrench or Socket 12mm....................................1
To install the canister support brace:
1. Place the canister support over the holes on
the base edge (Figure 11).
Canister Support
Figure 11. Canister support attached to base.
Components and Hardware Needed: Qty
Metal “L” Outlet ................................................1
Flange Bolts
5
⁄16"-18 x
1
⁄2"....................................8
Rubber Gasket ..................................................1
Tools Needed:
Wrench or Socket 12mm....................................1
To install the metal “L” outlet:
1. Place the rubber gasket around the impeller
outlet rim as shown in Figure 9.
Outlet
Figure 10. Metal “L” outlet attached to impeller.
Figure 9. Placing rubber gasket over outlet.
2. Secure the metal “L” outlet in place with the
flange bolts (Figure 10).
2. Secure the canister support in place with the
flange bolts.