Filter
Top Products
G0548 2 HP Dust Collector -15-
Components and Hardware Needed: Qty
Collector ............................................................1
Flange Bolts
5
⁄16"-18 x
1
⁄2"..................................10
Rubber Gasket ..................................................1
Tools Needed:
Wrench or Socket 12mm....................................1
To install the collector:
1. Place the rubber gasket in the outlet of the
collector.
2. Secure the collector to the metal intake with
8 flange bolts, (Figure 12).
Figure 12. Collector installed.
Components and Hardware Needed: Qty
Canister Filter ....................................................1
Canister Filter Cleaning Handle ........................1
Belt Clamp..........................................................1
Wide Foam Strip ................................................1
Tools Needed:
Wrench or Socket 10mm....................................1
To install the canister:
1. Secure the wide foam strip around the out-
side top rim of the collector as shown in
Figure 14.
Figure 14. Installing wide foam strip.
Figure 15. Trimmed foam strip.
2. Trim the excess foam strip so the ends come
together evenly, (Figure 15).
3. Attach the canister support to the side of the
collector with the 2 remaining flange bolts.
Canister FilterCollector Ring
Ends Matched
Together Evenly