Filter
Top Products
G0555X (Mfg. Since 1/12)
-13-
Main Components: (Figure 3) Qty
A. Stand .......................................................... 1
B. Bandsaw Unit ............................................. 1
C. Trunnion Base ............................................ 1
D. Lever Board ................................................ 1
E. Miter Gauge ................................................ 1
F. Extension Table .......................................... 1
G. Main Table .................................................. 1
H. Fence Assembly ......................................... 1
I. Resaw Fence ............................................. 1
J. Front Fence Rail ......................................... 1
K. Rear Fence Rail ......................................... 1
Fasteners and Tools: (not shown) Qty
• Rubber Feet (Stand) .................................. 4
• Hex Nuts
3
⁄8-16 (Feet/Stand) ...................... 8
• Flat Washers 10mm (Feet/Stand) .............. 8
• Hex Bolts M8-1.25 x 35 (Bandsaw/Stand) . 4
• Flat Washers 8mm (Bandsaw/Stand) ........ 8
• Lock Washers 8mm (Bandsaw/Stand) ....... 4
• Hex Nuts M8-1.25 (Bandsaw/Stand) .......... 4
• Hex Bolts M8-1.25 x 30 (Trunnion Base) ... 2
• Lock Washers 8mm (Trunnion Base)......... 2
• Hex Bolt M8-1.25 x 80 (Positive Stop) ....... 1
• Hex Nut M8-1.25 (Positive Stop) ............... 1
• Spacers (Lever Board) ............................... 4
• Cap Screws M8-1.25 x 60 (Lever Board) .. 4
• Hex Nuts M8-1.25 (Lever Board) ............... 4
• Set Screws M8-1.25 x 20 (Lever Board) .... 4
• Cap Screws M6-1 x 25 (Lever Board) ....... 4
• Lock Washers 6mm (Lever Board) ............ 4
• Flat Washers 6mm (Lever Board) .............. 4
• Knobs M10-1.5 (Table) .............................. 2
• Hex Bolts M6-1 x 20 (Front Rail) ............... 2
• Flat Washers 6mm (Front Rail) .................. 2
• Lock Washers 6mm (Front Rail) ................ 2
• Cap Screws M6-1 x 16 (Rear Rails) .......... 2
• Lock Handle M8-1.25 x 20 (Fence) ............ 1
• Hex Nut M8-1.25 (Fence) ........................... 1
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
A
B
C
D
E
F
G
H
I
J
K
Figure 3. Main components inventory.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
• Moving Plate (Resaw) ................................ 1
• Lock Handle M8-1.25 x 44 (Resaw) ........... 1
• Flat Washer 8mm (Resaw) ........................ 1
• Hex Wrenches 3, 4, 5mm .................1 Each