Filter
Top Products
-10- G1140 Edge Sander
Figure 4. Lead screw bracket Installed.
Figure 5. Installing the horizontal brace.
Figure 7. Horizontal / vertical brace installed.
Working Table
1. Bolt the lead screw bracket to the front of the
stand using the four Hex Bolts already
threaded in place. See Figure 4.
2. Thread the horizontal brace into position, but
do not tighten; the brace will require further
adjustment later on. See Figure 5.
Figure 6. Installing the lead screw assembly.
3. Locate the lead screw/table bracket assem-
bly and the handwheel. Thread the hand-
wheel onto the lead screw about halfway and
insert the lead screw into the lead screw
bracket. See Figure 6.
4. Locate the vertical brace. Turn the horizontal
brace approximately 45˚ and insert the verti-
cal brace through the hole at the end of the
horizontal brace. Rotate the horizontal / ver-
tical brace assembly to 90˚.
5. Install the hex nut and washer provided, and
screw on until
1
⁄2'' of the threaded end is vis-
ible above the washer. Insert the threaded
end of the vertical brace through the hole in
the bottom of the table bracket and re-install
the flat washer and hex nut back onto the
shaft. See Figure 7.