Filter
Top Products
G1140 Edge Sander -5-
We do not recommend the use of extension cords
on 220V equipment. It is much better to arrange
the placement of your equipment and the
installed wiring to eliminate the need for exten-
sion cords. Should it be necessary to use an
extension make sure the cord is rated Hard
Service (grade S) or better. Refer to the chart in
Section 1: Safety Instructions to determine the
minimum gauge for the extension cord. The
extension cord must also contain a ground wire
and plug pin. Always repair or replace extension
cords when they become worn or damaged.
Extension Cords
Your G1140 machine comes pre-wired for 220
volt operation. A wiring diagram is provided at the
back of this manual should it be necessary to
repair or revise the wiring. Always utilize a quali-
fied electrician when doing any electrical work on
this equipment.
Wiring Diagram
We have covered some basic electrical
requirements for the safe operation of your
Edge Sander. These requirements are not
necessarily comprehensive. You must be
sure that your particular electrical configu-
ration complies with local and state codes.
Ensure compliance by checking with your
local municipality or a licensed electrician.