Filter
Top Products
-20- G1140 Edge Sander
SECTION 7: MAINTENANCE
Lubrication
Table
Shielded and pre-lubricated ball bearings require
no lubrication for the life of the bearings. In a con-
tinuous-use environment, expect the bearings to
last for several years. With intermittent use, bear-
ings can be expected to last much longer. All
bearings are standard sizes and can be easily
replaced.
The table and other non-painted surfaces on the
Model G1140 should be protected against rust
and pitting. Wiping the sander clean after every
use ensures that moisture from sander dust isn’t
allowed to trap moisture against bare metal sur-
faces.
Some woodworkers recommend using automo-
tive paste wax on exposed steel and cast iron
surfaces. The wax provides a layer of protection,
as well as reducing friction between lumber and
the table, making cuts faster and smoother. Avoid
waxes that contain silicone or other synthetic
ingredients. These materials can find their way
into lumber that’s being worked, and can make
staining and finishing difficult. If you use paste
wax, make sure that it’s 100% Carnauba wax.
Make a habit of inspecting your sander each time
you use it. Check for the following conditions and
repair or replace when necessary.
1. Loose mounting bolts.
2. Worn switch.
3. Worn or damaged cords and plugs.
4. Damaged sanding belt.
5. Any other condition that could hamper the
safe operation of this machine.
General