Filter
Top Products
G0583 1 HP Canister Dust Collector -15-
Collection Bag
Components and Hardware Needed: QTY
Clear Collection Bag ...........................................
1
Lower Bag Clamp ...............................................
1
Wide Foam Strip .................................................
1
To install the collection bag:
1. Secure the wide foam strip around the out-
side bottom rim of the collector and trim the
excess (
Figure 12).
2. Slide the clear collection bag around the
bottom of the collector so the rim of the bag
overlaps onto the foam strip.
Figure 12. Installed and trimmed wide foam
strip.
Figure 13. Dust collection bag installed.
Wide Foam Strip
3. Tighten the lower bag clamp around the wide
foam strip to seal and secure the lower col
-
lection bag (
Figure 13).