Grizzly G0651 Saw User Manual


 


To make a rip cut:
1.  Preventing Kickback  Page 11
   

2. 

3. 
4.       

5. 

6.      



7. 

8.         
       

9.      
ON,


  

Ripping
Serious injury can be caused by kickback.
Kickback is a high-speed expulsion of stock
from the tablesaw toward an operator. The
operator or bystanders may be struck by
flying stock, or the operator’s hands can be
pulled into the blade during the kickback.
Note: The jointed edge of the workpiece
must slide against the fence during the cut-
ting operation.
10.        
Figure
41

Figure 41. 
Turn OFF the saw and allow the blade to
come to a complete stop before removing
the cut-off piece. Failure to follow this warn-
ing could result in serious personal injury.
Keep the blade guard installed and in the
down position. Failure to do this could
result in serious personal injury or death.