Support User Manuals

Grizzly G0704 Drill User Manual

Open as PDF

of 60





Drill Chuck

Figure 28. 

5. 





 Note: The chuck is attached to the arbor

using a B-16 taper. This attachment is con-

sidered to be semi-permanent. There should

be no need to remove the chuck from the

arbor.

4.       

     

       



         



To remove the chuck and arbor from the

spindle:

1. 

2. 

3.         



To install the drill chuck and arbor:

1. 

2. 

3. 

    



4.        



5.       

     

Figure28

NOTICE

The Model G0704 drawbar will extract the

arbor from the spindle. Once the arbor or

collet has broken free from the spindle

taper, be sure to properly support it while

continuing to loosen the drawbar. Failure

to properly support the arbor or collet

while loosening the drawbar will result in

the arbor or collet falling out of the spindle,

causing damage to machine components.

Note: Do not overtighten the drawbar.

Overtightening makes arbor removal difficult

and will damage the arbor and threads.

6. 

previous next