Grizzly G0724 Sander User Manual


  Open as PDF
of 36
 


Replacing
Sandpaper
    




     


AccessoriesPage 19
To replace the sanding disc:
1. 
2.        

3.        


5. 


6. 



Figure 12.

4. 
        
Figure 12
        


Disc Sanding
To reduce the risk of your fingers getting
trapped between the work table and sand-
ing disc, make sure the table is not more
than
3
⁄16" away from the sanding disc.
Figure 13.

High
Hazard
Low
Hazard
Kickback Hazard
Zone
Recommended
Sanding Area
When using this disc sander, it is important
to keep the workpiece firmly against the
table and ensure that sanding only occurs
in the downward rotation area of the disc, as
shown in Figure 13. Failure to do so increas-
es the risk of injury from loss of control by
the workpiece being grabbed or thrown.
 previous next