Grizzly G0724 Sander User Manual


  Open as PDF
of 36
 


Figure 15.

High Trapping
Angle Hazard
Low Trapping
Hazard
Low Kickback
Hazard
High Kickback
Angle Hazard
Open-Angle
Zone
Closed-Angle
Zone
Figure 16.
Note: For sanding curves or irregular shapes,
remove the miter gauge from the table. Always
keep the workpiece on the side of the wheel that
is rotating down toward the table (see
Figure 13).
To use the disc sander:
1. 
2.        



2.  ON 

3.        
       

4. 

Figures 1417

Figure 14. 


Figure 17.

Note:To prevent burning the workpiece and over-
loading the sanding disc, move the workpiece
back and forth slowly while sanding on the left
side of the sanding disc to the center.
Note:To perform sanding on compound-angle
cuts, tilt the table, and rotate the miter gauge to
the appropriate angles.
 previous next