Grizzly G0724 Sander User Manual


  Open as PDF
of 36
 



       

To calibrate the miter gauge:
1. 
2. 


Figure 26.
Miter Gauge
Calibration
3.        
         
  
       

4. 
  

5.       


Figure 26. 



To calibrate the table tilt:
1. 
2 

        
Figure 27.
Table Tilt Calibration
Note: This adjustment can be done with the
sandpaper installed, although it is more pre-
cise if the sandpaper is not installed.
3.    



4. 


5. 


Figure 27. 


 previous next