Filter
Top Products
G1028Z/G1029Z Dust Collector
-15-
5. Secure the front lower support bracket to the
collector with (2)
5
⁄16"-18 x
1
⁄2" flange bolts.
6. Place the upper support bracket over the
lower support bracket, and secure with (2)
5
⁄16"-18 x
1
⁄2" flange bolts, as shown in Figure
9.
Note: The collector attaches to each sup
-
port bracket. The inside of the collector is
funnel shaped and directs the air around in
a cyclone motion. Make sure that the inside
taper (funnel) is faced downward and the col
-
lector inlet faces toward the collector body.
7. Slip a loosened hose clamp over each end of
the flex-hose, and attach the ends over the
collector and collector body outlet. Tighten
each hose clamp until snug, as shown in
Figure 10.
8. Hook the top loop of the upper filter bag
(fabric) over the support bracket, as shown in
Figure 11.
Figure 11. Attaching upper filter bag.
9. Tighten the upper bag to the collector using
the clamp shown in Figure 12.
Figure 12. Upper collection bag secured.
Figure 9. Mounting collector to brackets.
Collector
Upper Support Bracket
Lower
Support
Bracket
Figure 10. Attaching flex hose onto collector
body outlet
.
Hose Clamp
Flex Hose
Clamp