Grizzly G1033X Planer User Manual


  Open as PDF
of 52
 


Figure 29. 
Table
Table
Head
Head
Parallel Parallel
Not-Parallel Not-Parallel
FRONT BACK

     Figure
29



    
      

Table Parallelism Inspection





       
        

      
       

Table Parallelism Adjustments

      
 

To adjust the table parallelism:
1.     

2.   

3. 
Chain TensionPage 28
4. 

5. 


Note: If the left side of the table is too high,
the left two sprockets will need to be adjusted.
Each tooth on the sprocket represents 0.016"
of vertical movement as the cogs are turned.
Make sure, as you turn the sprockets, to keep
an accurate tooth count to ensure that the
table is adjusted equally.
6.      




NOTICE
When making adjustments, tighten fasten-
ers after each step to ensure the accuracy
of your tests. When adjusting the chain
sprockets, keep in mind that if the chain
becomes too loose, it will fall off of all the
sprockets. Returning it to its proper loca-
tion can be frustrating.
 previous next