Filter
Top Products
3. Tighten the fasteners until the tool rest is secure. Figure 1.
4. Attach the eyeshield assembly to the threaded hole in the upper inside portion of the wheel
housing with one of the two smaller hex bolts or knobs provided.
5. Attach the eyeshields with the small screws, nuts, and washers provided. Adjust the eyeshield
to suit your needs by loosening the hex bolt or knob and moving to the desired position. Re-
tighten fastener. Figure 2.
Repeat steps 1-5 for the opposite side.
NOTE: The tool rest and eyeshield are designed to minimize the possibility of injury or equipment
damage. DO NOT operate this grinder without installing these pieces. ALWAYS WEAR PROPER
SAFETY DEVICES WHEN OPERATING THIS, OR ANY, MACHINERY. Grizzly Imports carries a
wide assortment of fine protective equipment. See the latest Grizzly catalog for prices and ordering
information.
VII. ELECTRICAL SERVICE REQUIREMENTS
A. CIRCUIT LOADING
Your Model G1062 and G1063 Bench Grinders are wired for 110/120V, single phase operation; nei-
ther can be operated at 220/240V. The
1
/3 H.P. motor on the G1062 will draw 4 amps at 110/120V.
The
3
/4 H.P. motor on the G1063 will draw 8 amps at 110/120V. These are not large loads. However,
if you operate your grinder on a circuit that is close to capacity, it might blow a fuse or trip a circuit
breaker. If an unusual load does not exist and power failure still occurs, have the circuit inspected
by a qualified electrician.
- 5 -
Figure 1
Figure 2