Filter
Top Products
-26- G1182 6" Series Jointers
SECTION 7: MAINTENANCE
Lubrication
V-Belt
General
Tables
Regular periodic maintenance on your Model
G1182 Jointer will ensure its optimum perfor-
mance. Make a habit of inspecting your jointer
each time you use it. Check for the following con-
ditions and repair or replace when necessary.
1. Loose mounting bolts.
2. Worn switch.
3. Worn or damaged cords and plugs.
4. Damaged V-belt.
5. Any other condition that could hamper the
safe operation of this machine.
The table and other non-painted surfaces on the
Model G1182 should be protected against rust
and pitting. Wiping the jointer clean after every
use ensures that wood dust isn’t allowed to trap
moisture against bare metal surfaces.
Some woodworkers recommend using automo-
tive paste wax on exposed steel and cast iron
surfaces. The wax provides a layer of protection,
as well as reducing friction between lumber and
the table, making cuts faster and smoother. Avoid
waxes that contain silicone or other synthetic
ingredients. These materials can find their way
into lumber that’s being worked, and can make
staining and finishing difficult. If you use paste
wax, make sure that it’s 100% Carnauba wax.
Inspect regularly for tension and wear; replace
when necessary with a size A-36 belt. Check pul-
leys to ensure that they are properly aligned. See
pulley/V-belt sections for proper tension and pul-
ley alignment procedures.
Since all bearings are shielded and permanently
lubricated, simply leave them alone until they
need to be replaced. Do not lubricate them.
Table ways and the fence assembly should not
be lubricated. If the tables appear to be stuck, dis-
assemble and clean any foreign materials from
the ways. Re-assemble and reset the gibs.
Disconnect power to the
machine when perform-
ing any maintenance,
assembly or adjust-
ments. Failure to do this
may result in serious
personal injury.
Wear safety glasses dur-
ing the entire mainte-
nance process. Failure
to comply may result in
serious personal injury.
Keep loose clothing
rolled up and out of the
way of machinery and
keep hair pulled back.