Filter
Top Products
G1182 6" Series Jointers -1-
G1182 Series Jointers
Terms and Definitions
G1182ZHW
Description
G1182HW G1182Z G1182ZX
Stand
Switch
Table Adjustment
Motor
Dust Collection
Weight
Cabinet
Toggle On / Off
Hand Wheels
1 H.P.
Chip Chute
215 lbs.
Steel Stand
Toggle On / Off
Hand Wheels
1 H.P.
Chip Chute
215 lbs.
Cabinet
Toggle On / Off
Levers
1 H.P.
225 lbs.
Heavy-Duty Cabinet
Magnetic w/ Light
Levers
1 H.P.
235 lbs.
Infeed Table: The infeed table is the table where
the cutting operation begins. When facing the
front of the jointer, it is on the right hand side.
The wood travels right to left; from the infeed
table, across the cutterhead, and onto the out-
feed table.
Outfeed Table: The outfeed table is the table
where the cutting operation ends. When facing
the front of the jointer, it is on the left hand side.
Cutterhead: The cutterhead is the cylindrical
assembly that holds each of the three jointer
knives. It spins on a horizontal axis between
the infeed and outfeed table, and is covered by
the cutterhead guard when the jointer is not in
use.
Fence: The jointer fence is the adjustable cast
iron surface that the wood stock runs along
when jointing and surface planing. The fence is
adjustable from 45° to 90° to the infeed and
outfeed tables.
Adjustment Levers and Handwheels: Controls
the height of the infeed and outfeed tables.
Table Lock Handles: The threaded handles that
must be loosened before the height of the
tables can be adjusted. They are then tight-
ened after the height is properly set.
Rabbet Cut: A rabbet cut is a groove cut along
the long edge of the wood stock. This cut is
typically used in carcass construction. The cut-
terhead guard must be removed for this opera-
tion so great care is needed for safe operation.
Surface Planing: Surface planing is running the
face of the wood stock over the jointer. This
provides one flat side that is ready to be run
through a dedicated planing machine.
Edge Jointing: Edge jointing is running the long
edge of the wood stock over the jointer. This
provides one flat edge that is ready to be run
against the table saw rip fence or edge glued.
Cutterhead Guard: The metal guard that covers
the cutterhead when wood stock is not passing
over the jointer.
Chip Chute With
Dust Hood
Chip Chute With
Dust Hood