Test Run
TroubleshootingPage 33
To test run the machine:
1.
2.
Important: When turning the sander ON, if
the sanding belt begins to track to one side or
the other, immediately turn the machine OFF
and disconnect it from power. Then, perform
the Tracking Roller & Platen Adjustment
procedure on Page 35.
3. ON
4.
5. OFF
Power Connection
After you have completed all previous setup
instructions and circuit requirements, the machine
is ready to be connected to the power supply.
To avoid unexpected startups or property dam-
age, use the following steps whenever connecting
or disconnecting the machine.
Connecting Power
Figure 25. Connecting power.
1. TurnthemachinepowerswitchOFF.
2. Insert the power cord plug into a matching
power supply receptacle. The machine is
nowconnectedtothepowersource.
Disconnecting Power
Figure 26. Disconnecting power.
1. TurnthemachinepowerswitchOFF.
2. Graspthemoldedplugandpullitcompletely
outofthereceptacle.Donotpullbythecord
asthismaydamagethewiresinside.