Filter
Top Products
G3690 Grizzly Imports, Inc. - 5 -
VII. OPERATIONS
C. CONNECTING TO AIR
To connect the air hose to the air nozzle at
the rear of the gun:
1. Pull back on the female hose connector
sleeve.
2. Press the fitting onto the nail gun air noz-
zle and release the sleeve. The female
fitting will lock onto the male gun fitting.
3. Listen for any air leaks. If no leaks are
detected, you are ready to test fire the
gun.
Always disconnect the air supply when the
gun is not in use because (1) a pressurized
gun is dangerous and (2) constant pres-
sure will reduce the life of the O-rings
inside the gun.
Prior to operating this nail gun, ensure that all
safety procedures are read and understood.
This tool is very simple to use and effectively
speeds production. However, ease of use and
routine production work may invite accidents.
Please practice safe work habits at all times
and always wear ANSI approved safety equip-
ment.
Figure 5 shows a closeup of the spring handle button.
Press to release pressure.
Figure 6 shows pressing down on the safety stop and
sliding the nails out.
Nail Stop
Spring Handle
Spring Handle Button
Nail Stop
Spring Handle
B. UNLOADING FASTENERS
Fasteners should be removed each time
you finish using the gun.
To unload the gun:
1. Disconnect the air hose if still connect-
ed.
2. Press the button inside the spring handle
finger hole. Figure 5. Guide the spring
handle to the front of the gun. DO NOT
LET THE SPRING HANDLE SNAP
BACK TO ITS RESTING POSITION!
3. Press down on the nail stop and slide the
nails out through the nail slot. Figure 6.