Filter
Top Products
-10-
G5954 5HP Dust Collector
Inventory
After all the parts have been removed from the
two boxes, you should have the following items:
Large Component Inventory (Figure
2) Qty
A. Casters (shown attached to base plate) ....
4
B.
Base Plate .................................................. 1
C.
Motor/Fan Assembly .................................. 1
D. Stand Legs ................................................. 4
E. Collector ..................................................... 1
Small Component Inventory (Figure
3) Qty
F. Gasket ........................................................ 1
G. 4-in-1 Inlet Adapter and Inlet Caps ............ 1
H. Upper Bag Support Extenders ................... 2
I. Lower Support ............................................ 1
J. Upper Bag Supports ................................... 2
K. Plastic Elbows 4" 90º ................................. 2
L. Lower Bags ................................................ 2
M. Upper Bags ................................................ 2
Other Components and Hardware Qty
• Flange Bolts
3
⁄8-16 x
1
⁄2" (A, B, C, D) ........ 32
• Washers
3
⁄8" (D, E) ................................... 16
• Hex Nuts
3
⁄8-16 (C, E, F) ............................ 8
• Hex Bolts
3
⁄8-16 x 1
1
⁄4" C, E, F) ................... 8
• Flange Bolts
5
⁄16-18 x
3
⁄4" (I, J) ................... 6
• Hex Nut
5
⁄8-11 (I) ......................................... 1
• Flange Bolts
1
⁄4-20 x
1
⁄2" (H, J) ................... 4
• Lower Support Foot Pad
5
⁄8-11 ................... 1
• Open-End Wrench 10/12mm ......................
1
• Bag Clamps ................................................
4
In the event that any nonproprietary parts are
missing (e.g. a nut or a washer), we would be
glad to replace them, or for the sake of expedi
-
ency, replacements can be obtained at your local
hardware store.
NOTICE
Some hardware/fasteners on the inventory
list may arrive pre-installed on the machine.
Check these locations before assuming that
any items from the inventory list are miss
-
ing.
SECTION 3: SET UP
Figure 2. G5954 Large Component Inventory.
D
C
A
B
E
Figure 3. G5954 Small Component Inventory.
F
G
H
I
J
K
M
L