Filter
Top Products
G5954 5HP Dust Collector
-13-
Collection Bags
Components and Hardware Needed: Qty
Upper Bag Supports ..........................................
2
Upper Bag Support Extenders ..........................
2
Lower Support ...................................................
1
Lower Support Foot Pad ...................................
1
Upper Collection Bags ......................................
2
Lower Collection Bags .......................................
2
Flange Bolts
5
⁄16-18 x
3
⁄4 ..................................... 6
Flange Bolts
1
⁄4-20 x
1
⁄2 ...................................... 4
To set up the collecton bags:
1. Screw the lower support foot pad onto the
bottom of the lower support.
2. Attach the lower support to the Collector
using two
5
⁄16-18 x
3
⁄4 hex bolts.
Figure 9. Fitting bag onto collector.
7. Repeat Steps 4 & 5 for the other upper bag.
8. Fit a lower bag over the bottom lip of the
collector, and fasten it in place with a bag
clamp.
9. Repeat Step 6 for the other lower bag.
3. Press-fit the 4-in-1 inlet adapter onto the col
-
lector inlet, as shown in Figure
8.
Figure 8. Installing 4-in-1 inlet adapter.
3. Attach each upper bag support to an upper
bag support extender using the
1
⁄4-20 x
1
⁄2 hex
bolts.
4. Attach each upper bag support to the Collector
using two
5
⁄16-18 x
3
⁄4 hex bolts.
5. Hang an upper bag from an upper bag sup-
port extender.
6. Pull the bottom of the upper bag over the lip
of the collector below it, and fasten it in place
with a bag clamp, as shown in Figure
9.