Filter
Top Products
-12-
G5954 5HP Dust Collector
Base and Motor/Fan
Components and Hardware Needed: Qty
Base ..................................................................
1
Casters ..............................................................
4
Flange Bolts
5
⁄16-18 x
1
⁄2" ................................. 32
Stand Legs ........................................................
4
Motor/Fan Assembly .........................................
1
To assemble the base:
1. Attach each caster to the underside of the
base using four
5
⁄16-18 x
1
⁄2" hex bolts.
2. Attach each leg to the underside of the fan/
motor assembly using two
5
⁄16-18 x
1
⁄2" flange
bolts, as shown in Figure
5.
Figure 5. Attaching legs to motor/fan assembly.
3. Attach the base to the legs using eight
5
⁄16-18
x
1
⁄2" flange bolts, as shown in Figure 6.
Figure 7. Mounting collectors to motor/fan
assembly.
Components and Hardware Needed: Qty
Gasket ...............................................................
1
Collector ............................................................
1
Flange Bolts
3
⁄8-16 x 1
1
⁄4" ................................... 8
Hex Nuts
3
⁄8-16 .................................................. 8
Flat Washers
3
⁄8 ............................................... 16
4-in-1 Inlet Adapter ............................................
1
Base/Motor/Fan Assembly ................................
1
To attach the collectors to the motor/fan
assembly:
1. Fit the gasket onto the outtake of the motor/
fan assembly.
2. Mount the collector to the motor/fan assem
-
bly using the flange bolts, flat washers and
hex nuts, as shown in Figure
7.
Collector
Figure 6. Attaching base to legs.
4. Turn the motor/base assembly right-side up
and place carefully onto the floor.