Filter
Top Products
G7148 12" Slip Roll -3-
MOUNTING & ADJUSTMENTS
Mounting Slip Roll
To mount the Model G7148 you will need to pro-
vide four
5
⁄16" bolts, nuts, lock washers, and eight
flat washers. To determine the length of the bolts,
add 1" to the thickness of your workbench.
1. Place the Model G7148 in the desired loca-
tion on the workbench. Make sure there is
enough room for the handle to move. (The
handle should be positioned on the right
when looking at the slip roll from the front.)
Make sure there is enough room behind the
slip roll to accommodate the material.
2. Mark the bench through the base, remove
the slip roll, and drill
11
⁄32" holes in the work-
bench.
3. Place the slip roll so the holes in the base
line up with the drilled holes, and install the
hardware in the following order: (1) Bolt, (2)
Flat Washer, (3) Slip Roll, (4) Workbench,
(5) Flat Washer, (6) Lock Washer, and (7)
Nut.
Wear safety glasses dur-
ing the entire assembly
process. Failure to com-
ply may result in serious
personal injury.
Some metal parts may
have sharp edges on
them after they are
formed. Please examine
the edges of all metal
parts before handling
them. Failure to do so
could result in injury.
Figure 1.
Adjusting
MATERIAL THICKNESS
The distance between the fixed shaft and the
front movable shaft allow for varying thicknesses
of material.
To increase the gap between the fixed shaft and
the front shaft, screw the front adjustment knobs
counterclockwise. Make sure you adjust both
knobs an equal amount. To decrease this dis-
tance, turn the knurled adjustment knobs clock-
wise. See Figure 1 for control locations and part
identification.
ROLL DIAMETER
The distance between the fixed shaft and the rear
movable shaft control the diameter of the roll.
To increase the distance between the fixed shaft
and the rear movable shaft, turn the knurled
adjustment knob counterclockwise. To decrease
this distance, move the adjustable knobs clock-
wise. Make sure you adjust both knobs an equal
amount.
Rear Movable Shaft
Front Movable Shaft
Fixed
Shaft
Front
Adjustment
Knob
Rear
Adjustment
Knob