Filter
Top Products
G7209/10 14'' Table Saw -19-
SECTION 5: ADJUSTMENTS
Blade Height
Blade Tilt
1. Set your blade angle at zero as shown on the
angle indicator on the front of the saw and
raise the blade several inches above the
table.
2. Place a machinist’s square flat on the table
and slide it along side the blade. The square
should contact the blade evenly from bottom
to top. Make sure that a blade tooth does not
obstruct the square’s movement.
3. Adjust the handwheel until the square is
flush with the blade. Loosen the tilt indicator
arrow, set to zero, and retighten. Loosen and
adjust the stop bolt on the left side of the
front trunnion to allow a 90° stop point. See
Figure 20.
4. Turn the blade angle handwheel until the
angle indicator points at the desired angle.
5. Tighten the handwheel locking knob.
6. Repeat Steps 1-6 for setting the blade to 45°
and adjust the 45° stop bolt on the right side
of the front trunnion. See Figure 20. Use the
45° side of a combo square or a bevel gauge
set at 45°.
Figure 20. 90° and 45° stop bolts.
When preparing to operate your table saw, you
should adjust the blade height to approximately
1
⁄4" above the surface of the material you plan on
cutting. The handwheel at the front of the saw
adjusts blade height. To adjust blade height:
1. Loosen the locking knob at the center of the
blade height handwheel.
2. Using a sample of the material you plan on
cutting as a gauge, turn the handwheel until
the blade reaches its intended height.
3. Retighten the locking knob.
4. Recheck your blade height with the sample
material and readjust, if necessary.
45° Stop Bolt
90° Stop Bolt
Disconnect power to the
machine when perform-
ing any maintenance,
assembly or adjust-
ments. Failure to do this
may result in serious
personal injury.
!
Keep loose clothing
rolled up and out of the
way of machinery and
keep hair pulled back.
Wear safety glasses dur-
ing the entire adjustment
process. Failure to com-
ply may result in serious
personal injury.