Filter
Top Products
G7209/10 14'' Table Saw -23-
Blade Alignment
The blade position can be adjusted slightly in
case it contacts the table insert when raised or
tilted. This adjustment can be made by moving
the table, the whole trunnion assemble, or by just
moving the arbor bracket. Try adjusting by mov-
ing the table first as this is the easiest way. If that
doesn’t work, try adjusting the whole trunion
assembly. If that still doesn’t work, try moving the
arbor bracket.
To adjust the blade position by moving the table:
1. Disconnect plug from power source.
2. Loosen the four table mounting bolts.
3. Nudge the table to either the left or right
depending on where the blade is hitting the
saw. Tighten all mounting bolts.
4. If the blade is still contacting the insert,
repeat Steps 1-3. Check all other adjust-
ments.
5. Recheck the blade to miter slot adjustments,
and adjust as necessary.
To adjust the blade position by moving the trun-
nion:
1. Disconnect plug from power source.
Figure 28.
Setscrews
Nylon Pads
PARALLELISM
Align the fence alongside the miter slot as shown
in Figure 29, and lock it down. If the fence is not
perfectly parallel to the miter slot:
1. Release the clamping mechanism.
2. Remove the fence from the saw and adjust
the setscrews on the rear side of the front
bracket as shown in Figure 28. Make VERY
minor adjustments and recheck by reclamp-
ing the fence along the miter slot after each
adjustment. Keep in mind that a small turn of
the setscrew can make a large difference
over the length of the fence. Be sure clamp-
ing pressure is still adequate.
Figure 29.
Figure 30A. Trunnion mounting bolts.