Filter
Top Products
G9717 6" Grinder
-2-
99.. UUSSEE PPRROOPPEERR EEXXTTEENNSSIIOONN CCOORRDD
. Make
sure your extension cord is in good condi-
tion. Conductor size should be in accor-
dance with the chart below. The amperage
rating should be listed on the motor or tool
nameplate. An undersized cord will cause
a drop in line voltage resulting in loss of
power and overheating. Your extension
cord must also contain a ground wire and
plug pin. Always repair or replace exten-
sion cords if they become damaged.
Minimum Gauge for Extension Cords
1100.. WWEEAARR PPRROOPPEERR AAPPPPAARREELL..
Do not wear
loose clothing, gloves, neckties, rings,
bracelets, or other jewelry which may get
caught in moving parts. Non-slip footwear
is recommended. Wear protective hair
covering to contain long hair.
1111.. AALLWWAAYYSS UUSSEE SSAAFFEETTYY GGLLAASSSSEESS..
Also
use face or dust mask if cutting operation
is dusty. Everyday eyeglasses only have
impact resistant lenses, they are NOT
safety glasses.
1122.. SSEECCUURREE WWOORRKK..
Use clamps or a vise to
hold work when practical. It’s safer than
using your hand and frees both hands to
operate tool.
LLEENNGGTTHH
AAMMPP RRAATTIINNGG 2255fftt 5500fftt 110000fftt
0-6 18 16 16
7-10 18 16 14
11-12 16 16 14
13-16 14 12 12
17-20 12 12 10
21-30 10 10 No
SSaaffeettyy IInnssttrruuccttiioonnss FFoorr PPoowweerr TToooollss
1133.. DDOONN’’TT OOVVEERRRREEAACCHH..
Keep proper footing
and balance at all times.
1144.. MMAAIINNTTAAIINN TTOOOOLLSS WWIITTHH CCAARREE..
Keep
tools sharp and clean for best and safest
performance. Follow instructions for lubri-
cating and changing accessories.
1155.. DDIISSCCOONNNNEECCTT TTOOOOLLSS
before servicing
and changing accessories, such as blades,
bits, cutters, and the like.
1166.. RREEDDUUCCEE TTHHEE RRIISSKK OOFF UUNNIINNTTEENNTTIIOONN--
AALL SSTTAARRTTIINNGG..
Make sure switch is in off
position before plugging in.
1177.. UUSSEE RREECCOOMMMMEENNDDEEDD AACCCCEESSSSOORRIIEESS..
Consult the owner’s manual for recom-
mended accessories. The use of improper
accessories may cause risk of injury.
1188.. CCHHEECCKK DDAAMMAAGGEEDD PPAARRTTSS..
Before fur-
ther use of the tool, a guard or other part
that is damaged should be carefully
checked to determine that it will operate
properly and perform its intended function.
Check for alignment of moving parts, bind-
ing of moving parts, breakage of parts,
mounting, and any other conditions that
may affect its operation. A guard or other
part that is damaged should be properly
repaired or replaced.
1199.. NNEEVVEERR LLEEAAVVEE TTOOOOLL RRUUNNNNIINNGG UUNNAATT--
TTEENNDDEEDD.. TTUURRNN PPOOWWEERR OOFFFF..
Don’t
leave tool until it comes to a complete stop.