Filter
Top Products
-4- Extreme Duty Planers
Like all power tools, there is danger associ-
ated with planers. Accidents are frequently
caused by lack of familiarity or failure to
pay attention. Use this tool with respect
and caution to lessen the possibility of
operator injury. If normal safety precau-
tions
are overlooked or ignored, serious
personal injury may occur.
No
list of safety guidelines can be complete.
Every shop environment is different. Always
consider safety first, as it applies to your
individual working conditions. Use this and
other machinery with caution and respect.
Failure to do so could result in serious per-
sonal
injury, damage to equipment or poor
work results.
Additional Safety Instructions For Planers
1. READ THIS ENTIRE MANUAL BEFORE
TURNING THE PLANER ON.
2. ENSURE
THAT THE MACHINE IS ON
FLAT, STABLE GROUND BEFORE USE.
Any
“wobbles” must be corrected by shim-
ming
or blocking before operation.
3. N
EVER PLANE MATERIAL OTHER
THAN WOOD WITH THIS MACHINE.
4. NEVER POSITION FINGERS OR THUMBS
NEAR THE INFEED ROLLER.
5. ENSURE THAT THE PLANER IS PROP-
ERLY
ADJUSTED AND THAT THERE
ARE NO LOOSE PARTS BEFORE OPER-
ATING.
6.
PLANE IN THE SAME DIRECTION AS
THE GRAIN OF THE WOOD STOCK.
7. ALWAYS STAND TO THE SIDE OF
THE PLANER WHILE FEEDING THE
WORKPIECE.
8.
DO NOT LOOK INTO THE MOUTH OF
THE PLANER DURING OPERATION!
9. ALWAYS PROVIDE ADEQUATE IN-
FEED AND OUTFEED SPACE WHEN
OPERATING THE PLANER. Always sup-
port
long pieces of stock on both sides of
the planer.
10. DO NOT REMOVE MORE THAN
1
⁄4"
FROM THE SURFACE OF THE WOOD
STOCK IN A SINGLE PASS.
11. INSPECT YOUR STOCK BEFORE PLAN-
ING. Never plane stock with nails, staples
or
other foreign objects which may be
embedded in the surface. Always properly
prepare workpieces before running them
through the planer. Do not plane lumber
with loose knots or knots that may become
loose during planing.
12. DO NOT ATTEMPT TO REMOVE JAMS
UNTIL POWER IS DISCONNECTED and
all moving parts have come to a complete
stop.
13.
DO NOT PLANE WORKPIECES LESS
THAN 12" LONG AND
1
⁄4" THICK.
14. DO NOT OPERATE PLANER WITH DULL
OR DAMAGED KNIVES.
15. ALWAYS UNPLUG THE PLANER
WHENEVER MAKING ANY
ADJUSTMENTS that
would bring your
hands near the cutterhead.
16. IF AT ANY TIME YOU ARE EXPERIENC-
ING
DIFFICULTIES PERFORMING THE
INTENDED OPERATION, STOP USING
THE PLANER! Then contact our service
department or ask a qualified expert how
the operation should be performed.