Filter
Top Products
-12-
G9749 Variable Speed Drill Press
The Model G9749 was carefully packed when it
left our warehouse. If you discover the machine
is damaged after you have signed for delivery,
please immediately call Customer Service at
(570) 546-9663
for advice.
Save the containers and all packing materials for
possible inspection by the carrier or its agent.
Otherwise, filing a freight claim can be difficult.
When you are completely satisfied with the condi
-
tion of your shipment, you should inventory the
contents.
Unpacking and
Lifting
The Model G9749 weighs 615 lbs. You will
need power lifting equipment and assistance
to remove this machine from the pallet and
position it. Inspect all lifting equipment and
make sure that all is in perfect working order
and is rated for the load before attempting
to lift and move this drill press. Ignoring this
warning may lead to serious personal injury
or death.
To unpack and move the drill press:
1. Read this entire SETUP section before
continuing. Pay special attention to Site
Considerations on Page 11 and Mounting
to Shop Floor on
Page 13.
2. Remove the sides and top of the shipping
crate.
3. Position the lifting straps under the headstock
as shown in
Figure 6. Make sure the straps
are not in contact with any controls, wires, or
handles.
Figure 6. Location of lifting straps.
4. Position lifting straps, your lifting device, and
your assistant to support the drill press in a
vertical and stable position.
5. Unbolt the drill press from the pallet.
6. Slowly raise the drill press from the pallet,
then carefully move the drill press to your
prepared location.
7. With the drill press securely resting on the
floor, shim between the floor and drill press
base as required to level the drill press
table.
8. Secure the drill press to the floor, but DO
NOT overtighten the fasteners.
9. Recheck the table to make sure that it is still
level, and re-shim as required.