Filter
Top Products
-18- Ultimate Series Jointers
1. Place a 45° gauge on the outfeed table fair-
ly close to the cutterhead as shown in Figure
16.
45° Fence Stop
Figure 16. Using a 45° gauge to align fence.
2. While holding the fence adjusting handle,
loosen the angle setting lock knob and the
checknut on the 45° stop screw as shown in
Figure 17
. Turn the stop screw against the
sliding bracket until the fence contacts the
edge of the 45° gauge evenly.
3. Tighten the checknut on the stop screw and
tilt the fence forward, then back against the
stop.
4. Recheck with the 45° gauge. Tightening the
checknut will move the stop bolt slightly, so
some trial-and-error may be necessary to
perfect your settings.
Figure 17. Setting the 45° stop.
45° Stop