Grizzly G9860 Biscuit Joiner User Manual


  Open as PDF
of 76
 


HigV^\]iZY\Z
Dji[ZZY >c[ZZY
Figure 23.
HigV^\]iZY\Z
Dji[ZZY >c[ZZY


Note: On the knife-style cutterhead models,
rotate the knurled knob on the cutterhead lock
pin underneath the back of the fence assem-
bly until it pops in toward the cutterhead. As
you rotate the cutterhead pulley, the pin will
engage one of the four indents on the stop
plate and lock the cutterhead in the correct
position for this procedure (see Figure 24.
To disengage the pin, pull it out and rotate it
1
⁄2 turn.
HideEaViZ>cYZci
AdX`E^c
@cjgaZY
@cdW
;ZcXZHjeedgi
Figure 24.
3.       
      
 

Figure 23
4. 

      

Note: Use the cutterhead pulley to rock the
cutterhead back-and-forth to make sure the
cutter is at TDC.
      

Step 6

Step 5
 previous next