Grizzly G9860 Biscuit Joiner User Manual


  Open as PDF
of 76
 


8.        
      
       

Figure 71
Note: Both of these screws are used to lock
the adjustment bolt in place.
8Vb
6Y_jhibZci
7dai
8Ve
HXgZl
HZiHXgZl
IVWaZ
Figure 71.

Note: The goal of the next step is to bring the
outfeed table parallel to the cutterhead body
from front-to-back by raising or lowering the
front corner of the outfeed table.
9. 
Figure 71

       
       
       
Step 4
10. 
Step 4

     
   Step 11    



 
       
   Step 9

      

11.       


Figure 71

12.        


Figure 72
Note: When adjusted to the correct outfeed
table height, use the stop bolt for a conve-
nient method of ensuring the outfeed table is
set at the proper height.
13.   Adjusting Outfeed Table
Parallelism    
   Adjusting Infeed Table
Parallelism
Adjusting Infeed Table Parallelism
1.        Adjusting
Outfeed Table Parallelism
     

2. 

    


Note: Make sure the straightedge is not in
contact with a knife or insert.
Figure 72.



 previous next