BdYZa<)%%%B[\#H^cXZ-$%.
"(."
NOTICE
Carriage feed rate is dependent upon the
spindle speed—higher spindle speeds
equal higher feed rates! Pay close attention
to the rate of the powered carriage move-
ment and keep your hand poised over the
feed lever to disengage it when necessary.
Failure to fully understand this could result
in the carriage crashing into the headstock
or tailstock causing severe damage to the
lathe.
V
W
)%
-%
)%
&',
&'%
AZkZg
V
W
;ZZY %#%%), %#%&'
.*&&
'- '- '- )'
+% +% +% +%
^ch
%#%%+( %#%%,-
Figure 55.BdYZa<)%%%[ZZYgViZX]Vgi#
c. 8dc[^\jgZi]Za VcYb X]Vc\Z\ZVgh
Vh Y^gZXiZY gZ[Zg id Change Gearsdc
Page 36 [dgYZiV^aZY^chigjXi^dch#
Note: When configuring the change gears
for non-threading feed rates, always have
the 120T gear facing out.
3. JhZi]Z]VcYl]ZZahidegdeZganedh^i^dci]Z
iddaV\V^chii]Zldg`e^ZXZi]Vi^hXdggZXi[dg
ndjgdeZgVi^dc#
4. Ejh]i]Z[ZZYaZkZgjeidZc\V\Zi]ZXVgg^V\Z
\ZVghl^i]i]ZaZVYhXgZlhZZFigure 54#
Note: It may be necessary to rock the car-
riage handwheel back-and-forth to mesh the
feed gear with the leadscrew.
5. Ejh]i]Z ]Va["cji aZkZgje idY^hZc\V\Z i]Z
]Va["cji [gdb i]Z aZVYhXgZl! Vh h]dlc ^c
Figure 54#
6. 8dccZXi i]Z aVi]Z id edlZg! i]Zc l^i] dcZ
]VcY ed^hZY dkZg i]Z [ZZY aZkZg! hiVgi i]Z
he^cYaZgdiVi^dc#
Note: The direction of the carriage reverses
when the spindle direction reverses.
7. L]ZcgZfj^gZY!ejh]Ydlcdci]Z[ZZYaZkZg
idY^hZc\V\Zi]ZXVgg^V\Z[gdbi]ZaZVYhXgZl
VcYhide^ihbdkZbZci#
Figure 54.;ZZYaZkZg^ci]ZZc\V\ZYje
edh^i^dc#
;ZZYAZkZg
:c\V\ZY
Je
=Va["CjiAZkZg9^hZc\V\ZYJe
NOTICE
NEVER attempt to engage the feed lever (up)
and half-nut lever (down) at the same time,
and NEVER force these levers. Otherwise,
severe damage to the lathe could occur.