Filter
Top Products
-12-
H7760 2" x 27" Belt Sander & 6" Grinder
Tool Rests Spark Guard
& Eye Shield
Figure 6. Tool rest installed and positioned near
the grinding wheel.
The tool rest attaches to the inward side of
the guard and provides a surface that must be
used to support the workpiece during operation.
Certain types of grinding/sanding may require
jigs or accessories that will be used with the tool
rests to assure the proper angle of the workpiece
against the wheel. Failure to install and use the
tool rest can lead to serious personal injury!
Components and Hardware Required Qty
Knob Bolt M5-0.8 ............................................... 2
Flat Washer 5mm ..............................................
2
Hex Nut M5-0.8 .................................................
2
To install the tool rests:
1. Loosely attach the tool rests perpendicular to
the belt or wheel surface with the knob bolts
and 5mm washers and hex nuts.
2. To adjust the angle of the sanding belt tool
rest, use a square or a protractor to set the
angle of the tool rest in relation to the sanding
belt.
3. Adjust both tool rests approximately
1
⁄16"-
1
⁄8"
from the grinding wheel and the sanding belt
and tighten the knob bolts.
Figure 6 shows
the correct adjustment for the tool rest at the
grinding wheel.
The spark guard must be installed and positioned
1
⁄8" from the grinding wheel to minimize sparks
flying towards the operator. The eye shield must
be positioned between the grinding wheel and
the operator’s face to protect the operator from
flying debris—this is not a replacement for safety
glasses!
Components and Hardware Required Qty
Eye Shield & Bracket .......................................
1
Eye Shield Support Arm ....................................
1
Support Arm Bracket .........................................
1
Spark Guard ......................................................
1
Flat Washer 8mm ..............................................
1
Hex Bolt
M8-1.25 ............................................... 1
Carriage Bolt M6-1.0 x 18 .................................
1
Flat Washer 6mm ..............................................
1
Hex Nut M6-1.0 .................................................
1
Phillips Head Screw M5-0.8 x 8 ........................
1
Flat Washer 5mm ..............................................
1
To install the spark guard and eye shield:
1. Using the included 5mm screw and washer,
install the spark guard as shown in
Figure
7.
2. Attach the eye shield to the support bracket
with the included 6mm carriage bolt, washer
and hex nut. Use the 8mm hex bolt and
washer to attach the support bracket to the
Figure 7. Spark guard and eye shield attached.
Attach Spark
Guard Here
Attach Support
Bracket Here
Attach Eye
Shield Here