Filter
Top Products
H3390 Wet Tile Saw -11-
4. Slide the plastic water reservoir into one end
of the saw frame as shown in
Figure 7
. Be
sure the reservoir is not protruding from
either end of the frame.
Figure 7. Installing the water reservoir.
8. Mount the motor assembly to the frame using
(2) M10-1.5 x 75 hex bolts, (2) M10 lock
washers, (2) M10 flat washers, and (1) M10-
1.5 x 15 setscrew as shown in
Figure 10
.
Figure 10. Mounting the motor assembly.
Water Reservoir
Motor Assembly
5. Slide the pivot shaft into the riser block as
shown in
Figure 8. Be sure the notched end
of the pivot shaft is positioned correctly.
6. Secure the assembly with a M10-1.5 x 10
setscrew as shown in
Figure 8
.
7. Slide the pivot shaft into the mounting holes
on the motor assembly and secure with the
blade height adjustment knob as shown in
Figure 9
.
Figure 8. Attaching the
pivot shaft to the riser
block
.
Figure 9. Securing the riser block to the motor
assembly using the blade height adjustment
knob.
Saw Frame
3. Mount the saw frame to the stand using (2)
M6-1.0 x 20 carriage bolts, (2) M6 external
tooth washers, and (2) M6-1.0 knob bolts as
shown in
Figure 6
.
Figure 6. Mounting the saw frame to the stand.
Setscrew
Setscrew
Mounting Holes
Notch
Blade Height
Adjustment Knob