Filter
Top Products
-4- H3390 Wet Tile Saw
1. Water Pump. Replace the water pump
with a replacement pump from our parts
department only.
2. Wet Hands. DO NOT touch connections
with wet hands.
3. Plug In. All plug and receptacles should be
off the ground and in a dry location.
4. Drip Loop. Always make a drip loop with
the power cord when using the saw
(Figure 18, Page 14).
5. GFCI. Always use a GFCI in the electrical
circuit of the saw (Figure 1, Page 6).
6. Water Flow. Ensure that a continuous flow
of water is present on both side of the saw
blade when cutting.
7. Dry Cutting. Never dry cut with blades
designed for wet cutting.
8. Blade Cooling. DO NOT make long con-
tinuous dry cuts. Allow the blade to cool by
running it in the air every few minutes.
9. Dust Mask. Always wear a dust mask
when cutting tile.
10. Diamond Blades. Diamond blades DO
NOT cut material, rather they grind materi-
Safety Instructions For Tile Saws
al. DO NOT feed the tile into the blade
faster than the blade can grind.
11. Blade Selection. Match the correct dia-
mond blade to the cutting operation being
performed.
12. Blade Mounting. Before mounting the
blade, inspect the arbor, arbor nut, and
flanges for damage or wear. Replace any
damaged or worn parts.
13. Blade Direction. Check that the direction-
al arrow on the saw blade points in a
counter-clockwise direction as viewed from
the mounting side.
14. Blade Arbor. Ensure the blade arbor hole
size matches the arbor shaft size on the
saw.
15. Blade Guard. Never operate the saw with-
out the blade guard installed and properly
adjusted.
16. Blade Speed. DO NOT exceed the blades
safe operating speed.
17. Side Grinding. Never grind tile on the side
of the blade, or make radius or curve cuts.