Filter
Top Products
-12- H3390 Wet Tile Saw
9. Attach the blade guard to the motor assem-
bly using the M8-1.25 x 30 lock knob and M8
flat washer as shown in
Figure 11
. Tile saw
blades are sold separately.
10. Place the water pump inside the water reser-
voir and plug the pump cord into the recepta-
cle on the side of the motor assembly. A plas-
tic hose runs from the pump to a “Y” connec-
tor and then slides through two mounting
holes on each side of the blade guard base
(
Figure 12).
11. Slide the chrome table rail through the
mounting holes on the table as shown in
Figure 13
.
12. Slide the silver aluminum rail cover over the
rail as shown in
Figure 14
.
Figure 11. Attaching the blade guard.
Figure 13. Assembling the table rail.
Figure 14. Assembling the rail cover.
Figure 12. Lube system.
Lock Knob
Table Rail
Rail Cover
“Y” Connector
Water Pump
Hose
Mounting
Holes
Blade Guard
Saw Table