Filter
Top Products
Figure 11.
To mount a router to the router table:
1.
2.
Figure 11
Mounting Router
NOTICE
Do not tighten the
clamp adjustment
bolts against the
thin edge of the
T-slots, or they may
break.
Figure 13.
3.
Figure 13
If the router unexpectedly moves or the
router bit contacts the table insert or fence
during operation, serious personal injury
could result from flying debris. ALWAYS
make sure that at least three router clamps
are used and are applied to a flat surface
of the router base before connecting the
router to power.
4.
Note: To properly position the hold-down
clamp, balance the tightness of the hold-
down knob and the adjustment bolt so that
the clamp will allow room for the router base
in the next step. It may be necessary to move
the jam nut on the adjustment bolt to the
other side of the hold down clamp, as shown
in Figure 12 to properly fit your router.
Figure 12.