Grizzly H7507 Router User Manual


  Open as PDF
of 32
 


Removing more than
1
⁄16" from the infeed
fence may greatly increase the risk of kick-
back injury when routing.
7.       
       
Step 5
8.      


Figure 30
HigV^\]iZY\Z
Dji[ZZY
;ZcXZ7dVgY
HigV^\]i
GdjiZg7^i
>c[ZZY
;ZcXZ7dVgY
IdeK^Zl
Figure 30.

9. 
       

Figure 31
IdeK^Zl
8jii^c\9^gZXi^dc
Figure 31.

Always feed the workpiece against the rout-
er bit rotation direction, as illustrated below.
Otherwise, the workpiece could be aggres-
sively pulled from your hands, drawing
them into the spinning cutter.
7^i
GdiVi^dc
Ldg`e^ZXZ
       

     
Step 8
6. 

Step 5



 previous next