Filter
Top Products
Model H7668 Spray Gun w/Pressure Cup-10-
Figure 7. Compressed air inlet location.
6. Attach the compressed air line to the
air inlet as shown in Figure 7. How-
ever, wait until you have mixed your
paint material and are ready to spray
to complete this step (see Spraying
on Page 11.
Note: Using a
1
⁄4" NPT quick discon-
nect set-up on the inlet air line (not
included and not shown), will make
operation and maintenance tasks
easier.
Note: For the best results, use a filter
that will extract water and oil contami-
nants and a hose that will be dedi-
cated for spray use only. Do not use
a hose that has been used with an
in-line oiler or other possible contami-
nant.
If you need additional help with this assem-
bly, call our Technical Support at: (570)
546-9663.
1. Fluid Control: Controls the volume of
material that travels through the fluid
tip.
2. Pattern Control
: Adjusts the spray
pattern from a round pattern to a wide
fan.
3. Atomizing Cap: Controls the spray
pattern from vertical to horizontal.
4. Trigger: Two stage trigger. Stage
one only releases compressed air for
blowing off the work piece. Stage two
sprays material.
5. Pressure Control Knob: Controls
the fluid pressure inside the spray
gun.
6. Safety Valve: Releases unsafe pres-
sure build-up from pressure cup.
Figure 8. Controls.
Controls
Safety Valve
Fluid Control
Pattern Control
Pressure Control Knob
Atomizing Cap
Trigger
Figure 9. Pressure cup controls.
Air Inlet