Filter
Top Products
H8145 Baby Table Saw
-15-
Fence Setup
The fence must be used to support the workpiece
whenever making cuts with this machine. The
fence can be setup for "Standard Cutting" and
for "Miter Cutting," depending on which way it is
attached to the table. Always verify that the fence
is set parallel to the blade before cutting.
Miter Cutting
For this type of cutting, the fence is setup facing
away from the blade, as shown in Figure 13. This
position is required to use the miter sled for 45°
miter cuts.
To setup the fence for miter cutting:
1. DISCONNECT SAW FROM POWER!
2. Attach each end of the fence with the includ-
ed knobs, flat washers, and lock plates, so
the fence is facing away from the blade.
3. Install the miter sled on the fence, as shown
in Figure 13.
Figure 12. Fence setup for standard cutting.
Figure 13. Fence setup for miter cutting.
The fence must be parallel to the blade to
keep the workpiece from binding during the
cut and causing a kickback. Make sure the
fence is parallel to the blade by ensuring that
both ends of the fence are firmly secured at
the same distance from the blade.
Standard Cutting
For this type of cutting, the fence is setup facing
the blade, as shown in Figure 12. This position is
used when making rip cuts, cross cuts, and bev
-
eled cuts. The workpiece is pressed against the
face of the fence for support as it is fed through
the blade.
To setup the fence for standard cutting:
1. DISCONNECT SAW FROM POWER!
2. Attach each end of the fence with the includ-
ed knobs, flat washers, and lock plates, so
the fence is facing the blade, as shown in
Figure 12.