Filter
Top Products
Model H8236 2-Piece Brad Nailer/Stapler Kit
-11-
A jammed nail/staple must be cleared
before using the tool again.
Brad Nailer
To clear a jammed nail from the dis-
charge area:
1. DISCONNECT NAILER FROM THE
AIR SUPPLY!
2. Depress the magazine latch and pull
the magazine cover back until it stops.
3. Remove the nail stick from the maga-
zine.
4. Remove the two cap screws and guide
cover from the nose assembly (see
Figure 8).
Clearing Jammed
Nails/Staples
Figure 8. Removing brad nailer guide
cover.
5. The jammed nail should now be visible;
remove it with needle nose pliers.
6. Re-install the guide cover with the two
cap screws removed in Step 4.
7. Throw the damaged nail away and
insert a new nail stick that only contains
clean, undamaged nails. DO NOT use
dirty or damaged nails!
8. Push the magazine cover all the way
forward until the magazine latch locks
it in place.
Stapler
To clear a jammed staple from the dis-
charge area:
1. DISCONNECT STAPLER FROM THE
AIR SUPPLY!
2. Unlatch and pull back the magazine
pusher, then remove the remaining
staples.
3. Remove the jammed staple with needle
nose pliers.
4. Throw the damaged staple away and
insert a new stick of staples that con-
tains only clean, undamaged staples.
DO NOT use dirty or damaged sta-
ples.