Filter
Top Products
Model H8236 2-Piece Brad Nailer/Stapler Kit
-13-
CLEANING & LUBRICATION
Cleaning
Use non-flammable solvent to clean
the nose assembly of the nailer/stapler.
Always be sure that the tool is dry before
using it again.
Do not allow dust, chips, sand, etc. into
the air connectors or into the body of the
nailer/stapler; this may result in leaks
and damage to the nailer and the air cou-
plings.
Lubricating
Standard pneumatic tool oil has been
included with your new Grizzly nailer/sta-
pler to help maintain its useful life. Place
two to six drops of oil in the tool air inlet
(as shown in Figure 9) before every use,
or after 2 hours of continuous use.
Wipe off any excess oil near the exhaust
port to avoid dust build-up. When the oil
that was included with the nailer/stapler
has been completely used, replace with
Grizzly Model G2820 Pneumatic Tool Oil.
Another option to manual oiling would be
to install a lubricator in your air compres-
sor line. If your air compressor line already
has a lubricator, then regular lubrication
of your nailer will not be necessary. Just
make sure there is always oil in the lubri-
cator.
Figure 9. Lubricating nailer/stapler via air
inlet.
Never clean this tool with gasoline
or other flammable liquids. Vapors
in the tool may ignite, causing the
tool to explode. Ignoring this warning
may lead to serious personal injury or
even death!