Filter
Top Products
G0462 Wood Lathe (Mfd. Since 11/14)
-17-
Figure 14. Example of removing switch key from
paddle switch.
5. Turn the machine OFF.
6. Remove the switch disabling key, as shown
in Figure 14.
7. Try to start the machine with the paddle
switch.
—If the machine does not start, the switch
disabling feature is working as designed.
—If the machine starts, immediately stop the
machine. The switch disabling feature is
not working correctly. This safety feature
must work properly before proceeding with
regular operations. Call Tech Support for
help.
The spindle speed lever adjusts the pulley
width to change the spindle speed. To pre-
vent damage to this mechanism, the lathe
MUST be running before using the variable
speed lever.
8. Re-insert the switch disabling key.
9. Turn the lathe ON.
10. Test the variable speed by pulling the speed
lever out (Figure 15) and slowly adjusting it
left and right.
— The machine should speed up and slow
down as you move the lever. If this is the
case, then the test run is over and your
machine is ready for normal operations.
—If the lathe has problems changing speeds,
turn the lathe OFF, disconnect it from
power, and refer to the troubleshooting
chart on Page 35, or call our Tech Support
at (570) 546-9663 for additional help.
Figure 15. Variable speed lever.
Variable
Speed Lever